The
switcher component dynamically decides which facet component should
be rendered. It has two properties. The switcher will render the
facet matching "facetName"; however, if no such facet
exists (or "facetName" is null), and "defaultFacet"
has been set, then that facet will be used instead.
Steps:
1.Create
VOs based on different tables in the Model Layer:
2.
In View Controller, create a View Page .Drag a Panel Group Layout
from the Component Palette onto the page.
3.
Drag the Switcher component from the Component Palette into the Panel
Group layout.
4.Right
Click the af:Switcher
component > Insert
Inside af:Switcher >
Facet
5.Provide
a Name for the Facet. Create 2 Facets and provide corresponding names
for both.
6.Drag
the 'Dept' VO from the Data Controls onto the Facet with name
'Query1' and create a table using the VO.
7.Repeat
the Step for 'Emp' VO and create the table in 'Query2' facet. The
structure would look as the figure below :
8.
Select the Switcher Component and change the DefaultFacet property to
'Query1'
9.In
the FacetName property of the Switcher, write #{requestScope.table}
10.
Drag a 'Choice' component from the component palette before the Panel
group layout .
Provide 2 static values (Facet Names that have been
created earlier are taken as Item Values)in the create list tab as
shown in the following figure.
11.
Change the AutoSubmit
property
of the Select One Choice to 'true' .
12.
Also Provide PartialTrigger
property
of the Panel Group Layout with the id
of the Select One Choice component.
13.
Run the Page.
